Metrohm 711 Liquino - Manual (Page 51)

3 Introduction
711 Liquino, Instructions for use 45
Various XDOS methods can be edited and stored in the method memory.
Each of these methods can then be reloaded by pressing a few keys. The
method memory is described on page 128.
Running the method
START
Z • When is now pressed the display shows
Di spl ay: Not pr epar ed yet !
Run PREP now?
ENTER
YES • Before the Dosino is used for the first time in the new configuration the
Dosino cylinder and the complete tubing system must be filled bubble-
free with the reagent solution. Press .
Di spl ay: Put t i p i n vessel !
Run PREP?
• Take care that the tip of the dosing tubing is located in a vessel and
then press . Wait until the 711 Liquino has ended the prepara-
tion (PREP). The instrument then returns to its normal state.
START
Z • From now on when is pressed the method will be run im-
mediately. *)
*) The warning about the preparation of the tubing system appears each time the mode is changed and after
the instrument has been switched off and on again. If it is certain that the Dosinos used have already been
prepared then press ( key) to acknowledge the warning. The method can now be run in the
normal manner by pressing .