Metrohm 711 Liquino - Manual (Page 13)

2. Installation
711 Liquino, Instructions for use 7
2.3 Setup
2.3.1 Connecting the keyboard
The keyboard is connected to the keyboard
socket provided for it on the rear panel of the
instrument.
2.3.2 Connecting the Dosinos
The Dosinos are connected to the sockets ”DOS1” to ”DOS4” on the rear
panel of the 711 Liquino. Press each Dosino plug into the socket until it
clicks into place!
Dos.1
A Dosino should only be connected when the instrument is switched off!
The 711 Liquino only recognizes Dosinos which are already plugged in
when it is switched on.
2.3.3 Connecting a Pt100 temperature sensor
The Pt100 temperature sensor 6.1111.030 with 4-wire technology can be
used with the 711 Liquino. It is connected to the socket marked with ”Pt100”
on the rear panel of the instrument.
The notch on the plug must coincide with the
marking on the panel.