Metrohm 711 Liquino User Manual
Page 33
3 Introduction
711 Liquino, Instructions for use
27
•
If you want, you can configure your Liquino so that after each dispensing
process the dosing cylinder is refilled automatically.
CONFIG
A
2x
J
•
Press the
Di spl ay:
conf i gur at i on
>manual
•
Here you will find the submenu with the settings which are effective for
manual functions.
Di spl ay:
>manual DOS1
← dosing connection
dos. uni t : def aul t
•
In the first line, above right, the address of the dosing connection to
which the particular setting applies is shown. You can make different
settings for each of the four dosing connections. The settings for the
other dosing connections DOS2 to DOS4 are also found in this sub-
menu. Now press the
Di spl ay:
>manual DOS1
aut o f i l l : of f
•
The colon after the word 'fill' shows that a list of entries is available for
this menu item. In this case there are only two possibilities: 'on' and
'off'.
DOS NR
SELECT
P
•
Press the
dosing unit. Confirm the entry with
2x
QUIT
NO
•
Exit the configuration menu by pressing
START
Z
•
Now dispense again by pressing the
the dosing cylinder is automatically refilled after each dosing process.
MANUAL
MAN OFF
D
•
Pressing the
again. The Liquino is again in the basic condition.