Metrohm 711 Liquino - Manual (Page 17)

2. Installation
711 Liquino, Instructions for use 11
Connection cables
Only Metrohm cables should be used to connect the 711 Liquino to other
instruments as these are the only ones with which interference-free data
transmission can be guaranteed.
Note:
Remote cables for the 711 Liquino always have a name on the end of the
cable to indicate the instrument with which the particular plug is intended to
be used and which connection it should be plugged in to.
Example:
Titrino B
692 / 712 / 713
Liquino — Titrino
B A Titrino
C
D
23
0
Cable 6.2141.090 is used in the SMPL mode. Details can be found on page
106ff.
Control commands can also be used in an SEQ method, for example:
>SEQ sequence st ep 4 ( CONTROL command)
pat t er n * 1* * - - - - starts Titrino (start pulse)
>SEQ sequence st ep 5 ( Pause command)
pause 00: 00: 01 wait 1 s
>SEQ sequence st ep 6 ( CONTROL command)
pat t er n * 0* * - - - - reset remote interface
(end pulse)
>SEQ sequence st ep 7 ( SCAN command)
pat t er n * * * * 1- - - wait for ready message from Titrino
cable 6.2141.090