Metrohm 711 Liquino - Manual (Page 21)

2. Installation
711 Liquino, Instructions for use 15
731 Relay Box settings:
Connect 772 Pump Unit to DC1 (or DC2)
Output voltage:
18 or 24 volt
Remote address selection disk DC1: 7 (=Output 7)
Connect heating bath to AC1 (or AC2,
mains voltage)
Remote address selection disk AC1:
2 (=Output 2)
711 Liquino settings
Temperature monitoring
XDOS mode (contained in SEQ mode):
Par amet er s
>XDOS moni t or i ng
t emper at ur e: on
l ow l i mi t xx° C
upper l i mi t . . .
act i on: . . .
al ar m pi ns: under
Control commands for the pump
SEQ mode
Switch on pump:
command: CONTROL
i nt er f ace: Remot e
pat t er n 1* * * - - - - (Output 7)
(switch off with 0* * * - - - - )