Metrohm 862 Compact Titrosampler - Manual (Page 60)

5.6 Performing a sample series ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
50 ￭￭￭￭￭￭￭￭ 862 Compact Titrosampler
￭ Enter the starting position of the sample series.
￭ Close the entry dialog with [BACK] or Accept.
The value for the number of samples remains saved for the next sam-
ple series. The position of the first sample is increased with each
method run.
You can still cancel the start of the sample series at this time with
[BACK] or [STOP].
4 Activate or deactivate the sample table
If the sample table is activated, the sample data of the sample table
is used. If the sample table is deactivated the sample data of the
main dialog is used.
5 Close the sample series dialog
Close the dialog with the [BACK] key.
6 Start the sample series
Press the [START] key.
Stopping a sample series
A sample series can be canceled at any time.
A sample series can be canceled at any time. When this is done, instru-
ments connected via remote connections, such as a Dosimat plus or an
843 Pump Station will also be stopped.
1 Press the [STOP] key.
The method run is stopped. The sample series cannot be resumed.
5.6.2 Pausing a sample series and continuing
Interrupting a sample series
A method run of the 862 Compact Titrosampler can be paused and then
continued again. The connected instruments are however not stopped.