Metrohm 862 Compact Titrosampler - Manual (Page 27)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
862 Compact Titrosampler ￭￭￭￭￭￭￭￭ 17
5 Use the four knurled screws to remount the cable and tubing cover.
Caution
Close the safety shield again after the titration head has been equipped.
The 862 Compact Titrosampler is not permitted to be operated unless
the safety shield is correctly mounted.
3.6 Connecting a stirrer
A DIN socket for connecting a rod stirrer 802 Stirrer is located on the
rear of the instrument.
Figure 9 Rod stirrer 802 Stirrer
Take care to observe correct orientation of the contact pins when plug-
ging in the connection cable. The rib on the outside of the plug must
match the reference mark (above) on the socket.
Figure 10 Connecting a stirrer