Rockwell Automation 2090 Ultra3000 Servo Drives Integration Manual - Manual (Page 39)

Publication 2098-IN005C-EN-P — March 2008
Commissioning Your Ultra3000 Drive 39
9. Using this table, determine the sequence of these three inputs that
correspond to the preset positions entered.
In this example, Preset Position 0 and 1 are configured so Preset
Select 0 is either off (Preset Position 0) or on (Preset Position 1).
10. Double-click the Monitor branch.
The (default) Drive Status parameters display.
11. Click Setup.
The Monitor Setup dialog opens.
Preset Selects
Binary Code
Selected Preset or Index
5 4 3 2 1 0
Select up to 64 locations via preselect inputs
5…0 by using BCD format.
(codes for preset selects 1 and 0 are shown)
0 0 0 0 0 0 Preset 0 or Index 0 is selected.
0 0 0 0 0 1 Preset 1 or Index 1 is selected.
0 0 0 0 1 0 Preset 2 or Index 2 is selected.
0 0 0 0 1 1 Preset 3 or Index 3 is selected.
1 1 1 1 1 1 Preset 64 or Index 64 is selected.