Rockwell Automation 25-COMM-E2P PowerFlex 25-COMM-E2P Dual-Port EtherNet/IP Adapter - Manual (Page 25)

Rockwell Automation Publication 520COM-UM003A-EN-E - June 2013 25
Chapter
3
Configuring the Adapter
This chapter provides instructions and information for setting the parameters to
configure the Dual-port EtherNet/IP adapter.
For a list of parameters, see Adapter Parameters on page 125 . For definitions of
terms in this chapter, see the Glossary on page 161 .
Configuration Tools The parameters can be configured using the drive keypad interface (see page 25 )
or a PowerFlex 4-class HIM (Human Interface Module, see page 27 ).
Software such as RSLogix 5000 (version 17 or greater), Logix Designer (version
21 or greater), and Connected Components Workbench (version 3 or greater)
can also be used to access the parameters.
Using the Drive Keypad
Interface to Access
Parameters The following is an example of basic integral keypad and display functions. This
example provides basic navigation instructions and illustrates how to program a
parameter.
Topic Page
Configuration Tools 25
Using the Drive Keypad Interface to Access Parameters 25
Using the PowerFlex 4-Class HIM to Access Parameters 27
Using a BOOTP or DHCP Server 28
Using Adapter Parameters 31
Setting the Data Rate 32
Using Master-Slave Hierarchy 33
Setting a Fault Action 34
Resetting the Adapter 36
Viewing the Adapter Status Using Parameters 37
IMPORTANT The Dual-port EtherNet/IP adapter Device parameters can be accessed on the
drive keypad via the “N” (Network) group. Note that the parameters in the “N”
group will appear offset from the Device parameter numbers referenced in this
manual by 1000 (decimal) on the LCD display.