Lenze CANopen Controller-based Automation - Manual (Page 79)

9 Commissioning of the CANopen Motion bus
9.8 Creating a control configuration
79
Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. Use the CANbus tab to set the baud rate.
3. Use the command Add Device to add the "CANopen Manager" to the control
configuration.

Note!
The baud rate set in the »PLC Designer« overwrites the baud rate set for the field devices
via »WebConfig« or »Engineer«.
Always set the same baud rate for all nodes in a CANopen network.