Lenze CANopen Controller-based Automation - Manual (Page 73)

9 Commissioning of the CANopen Motion bus
9.6 Configuring the communication parameters
73
Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3. Click the Scan network button.
4. Select the suitable controller for the IP address entered under 2. and activate it by
means of the Set active path button (or by double-click).
5. Now you can execute the following action using the »PLC Designer«:
 Logging in on the Lenze Controller with the »PLC Designer« ( 91)