Lenze CANopen Controller-based Automation - Manual (Page 101)

14 Diagnostics
14.5 »PCAN view« for diagnostic purposes
101
Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14.5 »PCAN view« for diagnostic purposes
This chapter describes how to use the »PCAN view« program for diagnostics of your CANopen
network.
»PCAN view« is the basic version of the »PCAN explorer« program of PEAK System Technik GmbH.
The program allows for simultaneous transmission and reception of CAN messages which can be
sent manually and periodically. Errors on the bus system and memory overflows of the controlled
CAN hardware are displayed.
14.5.1 Monitor telegram traffic on the CANopen bus

How to monitor the telegram communication:
1. Directly connect the Engineering PC to the CANopen bus via the EMF2177IB USB system
bus adapter.
2. Start the »PCAN view« program.
3. Connect »PCAN view« to the USB system bus adapter with the desired baud rate via the
"Connect to CAN Hardware" tab.
Example: