Lenze CANopen Controller-based Automation - Manual (Page 62)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17
62
8 Commissioning of the CANopen Logic bus
8.11 Preparing the restart
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.11.3.2 Automatic restart with factory adjustment

Settings for automatic initialisation with factory adjustment by the Lenze Controller:
1. Enter all desired parameter values under the All parameters tab.
2. Tick "Default settings" under the CANopen Remote Device tab.
When the I/O system has been replaced
1. Set the node address and the baud rate at the code switch.
2. Start the Lenze Controller.