Lenze 8400 - Manual (Page 245)

Commissioning
Quick commissioning
Keypad control
7

245 EDS84ASC552 EN 9.1
7.2.1 Keypad control
Commissioning steps
1. Wiring of power terminals
Consultthe”Electrical installation” chapterorthemountinginstructions towirethepower
connections according to the requirements of your device.
2. Wiring of control terminals.
– StateLine
Digital inputs at terminal X4 Assignment Information
24E DI1 DI2 DI3 DI4 RFR
X4
DO1 GIO 24I
RFR  Controller enable
RFR = High
 Reset error
High  Low (edge-controlled)
– HighLine/TopLine
Digital inputs at terminal X5 Assignment Information
24E DI1 DI2 DI3 DI4 RFR X5 DI5 DI6 DI7 GI 24I
RFR  Controller enable
RFR = High
 Reset error
High  Low (edge-controlled)
3. Load Lenze setting to controller

Note!
The application ”actuating drive speed” is implemented with the Lenze
setting.
MCTRL: Act. speed val.
C00051
0 rpm
After attaching the keypad or
switching on the controller with
keypad attached, the connection
between keypad and controller is
established.
The connection has been established
when the code C00051 appears in
the display.
 Then press the left function key.
SAVE
Par1 8400 StateLineC
User - Menu
Code list
Quick commissioning
SAVE
Par1 Quick commissioning
Terminals
Keypad
EDIT
Load Lenze setting
C00002/1
 Starting from ”User menu” scroll
down with button to ”Quick
commissioning” menu

Click right button.
 Select ”Keypad” menu.
 Click right button.
 Code 00002/1:
– Parameterise with left ”Edit”
function key
– Select value ”1”- -> On/Start
and confirm with right ”OK”
function key.