Lenze 8400 - Manual (Page 239)

Electrical installation
TopLine C control terminals
Axis bus
6

239 EDS84ASC552 EN 9.1
6.9.3 Axis bus

Note!
This connection is not supported in versions below 8400 TopLine, SW version
02.00. This connection must not be wired in these lower versions.
X10
,
" " "
CAN-Ground
X10
CAN-Low
CAN-High
Sync/State
EDS84AVxxxx
AL A
H
AG
R R
CA
O
N
AB
AS AL A
H
AG AS
120Ω
8400TLC002o 8400TLC009
Terminal data
Conductor cross-section Tightening torque

[mm 2 ] [AWG] [Nm] [lb-in]
Flexible
0.2 ... 1.5 24 ... 16 - - -
With wire end ferrule
I/O axis bus
Labelling Feature Rated value
X10/AS I/O axis bus connection TTL level: 5 V
X10/AG GND, reference potential: I/O axis bus