Nanodac – Carbolite nanodac User Manual
Page 86
nanodac™
MC27 –EN– 1.04
84
Counter Example (Cont.)
14. At Virtual Channel.3.Main, use the down arrow to select ‘Preset’. Press and hold the scroll key. The
top level User Wiring page appears.
15. Use the up (or down) arrow button to select the ‘From Source’ tab, if not already selected.
16. Operate the Scroll key to highlight ‘Add new wire’, then again to display the top level parameter list.
17. Use the down arrow button to highlight ‘Channel’ and operate the scroll button.
18. Use the down arrow button to highlight ‘2’ and operate the scroll button.
19. Highlight ‘Alarm 1’ and operate the scroll button.
20. Use the down arrow button to highlight ‘Acknowledgement’ (not ‘Acknowledge’). Operate the Scroll
button again, and create the new wire.
Figure 4.2c Wiring a counter: part 3
User Wiring
User Wiring
From source
To destination
Add new wire
1
2
Main
Trend
Alarm1
Alarm2
Virtual Channel.3.Main.Trigger
Virtual Channel.3.Main.Trigger
User Wiring
Virtual Channel.3.Main.Trigger
User Wiring
Virtual Channel.3.Main.Trigger
User Wiring
Virtual Channel.3.Main.Trigger
User Wiring
Virtual Channel.3.Main.Trigger
Instrument
Network
Group
Channel
Virtual Channel
Loop
Digital I/O
Alarm1
Create New Wire
Cancel
OK
Instrument
Network
Group
Channel
1
2
3l
From source
To destination
Add new wire
Channel.1.Alarm1.Active
Type
Status
Threshold
Inactive
N.acknowledged
Acknowledgement
Channel