Nanodac – Carbolite nanodac User Manual
Page 117
nanodac™
115
MC27 –EN–1.04
13.2 Application Example 2 - Program Load by Program Number
The "Program_LoadControl.vi" is an Application example which allows the user to load a program stored
in the instrument using numbers, and to Run/Hold or Reset a preloaded Program.
This feature has been added in the nanodac instrument from firmware versions 5.00 and above.
To open and load this file, repeat the steps listed in Example 1.
Figure F2 Program Load by Program Number (showing Context Help)
The following parameters may be monitored/adjusted:
Select the Program Number. If the number entered is not available in the instrument it will not be
recognised and an error message shown in the Program Load Status box
Run/Hold/Reset the program
Monitor the running program