Carbolite nanodac - Manual (Page 40)

nanodac™
MC27 –EN– 1.04
38
PROGRAM LOAD - QUICK ACCESS
From firmware version V5.00 and above a quick selection of an internally stored program may be made
directly from the Program Summary page. The programmer must be in Reset. Press and hold the scroll
key for 2 seconds. The page will go immediately to the file explorer page with the ‘User’ drive selected
and the ‘Operation’ parameter set to ‘Load’. The first program file will be selected (assuming different
programs have been configured). Use the Up/Down keys to select the required program followed by the
scroll key to load it.
If the selected file cannot be loaded (for example, the programmer file is for a different number of
channels) then an error message is shown on the file explorer.
The Quick Access to load mode adheres to the access security settings set in configuration mode -
Programmer set up.
Note: Quick load is disabled when in Edit mode. This is indicated by the highlighted parameter showing
the raise/lower symbol to the right of its value.
Figure 1.4.9k Program load display
User
Kiln1.UIPZ
Kiln1 type 2.uipz
kiln2.uipz
furnace1 purge.uipz
Ramp
Events
PV
PSP
Mode
Ch1 PSP
Ch1 TSP
Reset
14.3
140.0 Status
Seg Time Left
Ch1 Rate
Reset
00 :00 :44
01
Press and hold
the Scroll key
for 2 seconds