Carbolite nanodac - Manual (Page 5)

nanodac™
3
MC27 –EN–1.04
1. Nanodac password security
While in Logged out mode the control loop can be viewed but no alterations can be made. The
program page can be viewed but no change in status or editing of the program can be made.
Various chart pages can be viewed along with said history for charts. Operator notes can be
viewed and written to charts and message log.
Password codes: Operator level: 9
Password codes: Supervisor level: 5
Password codes: Engineer level: 95
While in Operator mode all of the above is available plus you can change the set point of the
control loop. Change the status of the program (i.e. Run, Hold or Reset).Edit, store, and load or
delete a program. Carry out a demand archive to a device and choose what device said archive
should be sent to (USB or FTP server). See main manual for details.
While in Engineer mode the following can be change: Time; Date; Communication setting.
2. Login
LOG IN Procedure for the Eurotherm Nanodac Controller/Programmer
Switch on the Instrument. Also refer to section 4.3.8.
To run a program you must ‘log in’. To log in follow the instructions below.
Press the Home button (Left hand button) to bring up the LOG IN screen as shown below.
Highlight the Log in by using the Up/Down arrows (right hand buttons).
Press the Scroll button (2 nd button from the LHS) to move to the access screen as shown below.