Carbolite nanodac - Manual (Page 74)

nanodac™
MC27 –EN– 1.04
72
6.5.2 Digital Event display
Clicking on the ‘Digital Events Output’ tool bar icon produces a segment display, allowing the user to
select the events on or off as required, for each segment. Figure 3.6.2 shows a programmer where the
number of events is four.
The number of events which appear (maximum eight) is configured in the Programmer Setup menu.
Figure 3.6.2 Event on/off configuration
6.5.3 Program parameters
The number of parameters which appear in this display depends on which program features are enabled.
Figure 3.6.3 shows a basic set of parameters which allows the user to select Rate or Time as the Ramp
style, and to select a value for Rate units.
Figure 3.6.3 Program parameter display