Carbolite nanodac - Manual (Page 113)

nanodac™
111
MC27 –EN–1.04
12.15 Status Icons
The Status icons are shown in the lower left of those pages that are automatically
updated (i.e. not the Message Summary page).
They indicate the following:
Security Enabled or Disabled in the nanodac instrument.
Recording Status
Green shows recording enabled e.g. when the instrument is not in configuration mode.
Red shows recording disabled e.g. when the instrument is in configuration mode.
Any Channel Alarm Status. This flashes when any alarm is present, whether acknowledged or not.
Any new messages. Go to the Message Summary page to view any new messages. This icon is then
removed from the other pages.
Any system alarm
Note: the update rate for the status icons is inherited from the current page.
12.16 DHCP Support
DHCP is managed in the web server in as much as the web server will not be allowed to come online until
the nanodac has received a valid IP address. The server will continually monitor the IP address and, if at
any point an invalid address is found, the server will shut down and re-start.
12.17 Network Protocols
The web server is in no way mutually exclusive with all other network protocols on the nanodac, however,
to achieve the best results from the web server it is recommended that no other communication protocols
are active at the same time.
12.18 Languages
The web server will only support English for all static text. Any channel descriptors or units that have been
configured at the target in another language will be displayed in that language on all web pages where
they are visible.