Carbolite nanodac - Manual (Page 32)

nanodac™
MC27 –EN– 1.04
30
Programmer Display Mode (cont.)
PROGRAM RUN/RESET/HOLD
Programs can be controlled by users with the correct access level (defined in Programmer configuration.
The display page is placed in edit mode by operation of the scroll key (‘Mode’ highlights). A second
operation of the scroll key followed by operation of the up/down arrows allows the user to select ‘Run’,
‘Hold’ or ‘Reset’. A further operation of the scroll key initiates the selected action.
Figure 1.4.9c Setting the Mode
Notes:
1. These functions can also be carried out by wiring relevant inputs to the ‘Run’, ‘Hold’ or ‘Reset’
parameters in Programmer configuration.
2. The user must have either ‘Logged off’, ‘Operator’ or ‘Supervisor’ level access as defined in
‘Prog Mode Access’ in the Programmer. The program cannot run if the unit is logged into at
‘Engineer’ level.
PV
PSP
Ramp
Progrm name
Mode
Ch1 PSP
Reset
14.3
Status Reset
Reset
14.3
Reset
15.7
Hold
18.9
Run
17.3
‘Hold’ appears only if
the program status is
‘running’.