Konica Minolta bizhub PRESS C1100 - Manual (Page 92)

Using the Konica Minolta FD-5 spectrodensitometer to
measure a color chart and create a profile
Requirements:
● The press must already be calibrated.
● The Konica Minolta FD-5 spectrodensitometer must be
connected to the IC-312 print controller as follows:
1. Connect the FD-5 to the IC-312 print controller.
2. Attach the FD-5 to the Target Mask.
3. Correctly set the device on the White Calibration plate that
has the same pairing number as the device.
4. Push down on the device until you hear a beep.
A message appears on the monitor indicating that the device
is calibrating.
5. Release the device when you hear a beep indicating that the
calibration is complete.
82 Chapter 7—Managing color