Konica Minolta bizhub PRESS C1100 - Manual (Page 157)

Parameter Option Description
Marks and
barcodes Marks and
barcodes Enables you to add a mark set that was defined in the
Resource Center, and define on which sheets the marks
appear.
Provides the following options:
● All—Prints the marks on each sheet in your job
● Repetition—Prints the marks according to the
frequency that you define—for example, if you set the
repetition to 3, the marks will be printed every third
sheet
● Sheet Range—Prints the marks according to the sheet
range that you defined. Provides the following options:
○ Type a range of sheets with a hyphen between the
starting and ending numbers in the range—for
example,
1-5
○ Type a range of sheets with a hyphen or comma
between the starting and ending numbers, and
where the last sheet=n
● 1,n (first and last sheets)
● n–1 (the sheet before last)
● n- (the integer stands for the number
of sheets before the last sheet)
Note: The sheet range option is applicable to
finishing marks, registration marks and barcodes.
To find out how to define marks and barcodes, see the
section on using mark sets.
Image alignment Image alignment Position of the image relative to the defined printable area:
● Left—Printed image is aligned to the top left side of the
printable area
● Right—Printed image is aligned to the top right side of
the printable area
● Center—Image is placed in the center of the printable
area
Custom offset Enables you to place the image according to the custom x
and y values that you type.
Front - X(Width), Y(Length)
Back - X(Width), Y(Length)
Align back with
front Enables you to apply the front settings to both the front and
back.
Delivery Face up Delivers the job face up
Working in IPDS mode 147