Konica Minolta bizhub PRESS C1100 - Manual (Page 36)

Creating calibration tables with the X-Rite i1/i1iO/
iSis spectrophotometer
This section describes how to connect and use the X-Rite i1/i1iO/
iSis spectrophotometer to create calibration tables.
See also:
Connecting the X-Rite i1/i1iO/iSis spectrophotometer to the IC-312
print controller
on page 26
Using the X-Rite i1 spectrophotometer to create a calibration table
on page 27
Using the X-Rite iSis spectrophotometer to create a calibration
table
on page 31
Using the X-Rite i1iO spectrophotometer to create a calibration
table
on page 35
Connecting the X-Rite i1/i1iO/iSis spectrophotometer to the
IC-312 print controller
Before you connect the X-Rite i1iO or iSis to the IC-312 print
controller, make sure that it is connected to the power outlet and
has been calibrated and set according to the manufacturer's
specifications.
Connect the USB cable that is included with the X-Rite i1/i1iO/
iSis spectrophotometer to both the X-Rite i1/i1iO/iSis
spectrophotometer and the USB port at the back of the IC-312
print controller.
The first time the X-Rite i1/i1iO/iSis spectrophotometer is
connected to the IC-312 print controller, the driver is installed
automatically. When the driver installation successfully
completes, you are ready to use the i1/i1iO/iSis
spectrophotometer to create a calibration table.
26 Chapter 3—Calibration