Konica Minolta bizhub PRESS C1100 - Manual (Page 59)

Troubleshooting calibration
Resolve common troubleshooting problems that can occur during
the calibration process.
Message Recovery action
Values collected during the measurement
are not monotonous. This message might appear after calibration
measurements. Run the calibration procedure
again, and if the problem persists, contact your
service representative.
The i1 is not calibrated. Place it on the
base and click OK to proceed. Place the X-rite i1 back on its base to re-calibrate
it.
The software cannot identify any
calibration device. Check that a device
is connected and that you have defined it. Make sure that the i1 is connected correctly to the
USB port of the IC-312 print controller. When
prompted, install the driver.
Troubleshooting calibration 49