Konica Minolta bizhub PRESS C1100 - Manual (Page 37)

Using the X-Rite i1 spectrophotometer to create a calibration
table
Requirements:
● Your spectrophotometer must be connected to the USB port on
the IC-312 print controller. The first time you connect the device
to the IC-312 print controller you are notified that the driver is
being installed. Wait for the driver installation to finish before
proceeding further.
● Make sure that your spectrophotometer is calibrated by placing
the spectrophotometer on its calibration plate.
● The Print queue must be ready for printing (not suspended),
and the printer must be warmed up.
1. From the Tools menu, select Calibration or select the
Calibration icon on the toolbar.
2. From the Measuring device drop-down list. select i1.
The following message appears while the IC-312 print
controller connects to the i1.
Using the X-Rite i1 spectrophotometer to create a calibration table 27