Konica Minolta bizhub PRESS C1100 - Manual (Page 203)

Parameter Option Description
Stapler sub tray ● Multi hole punch—This option is available only if the multi hole
punch module is connected.
● Punch—The values vary according to the type of punch unit
connected. The number of holes is 2, 3, or 4.
Stapler Main
tray ● Staples
○ None
○ Rear
○ Front
○ Dual
● Multi hole punch—This option is available only if the multi hole
punch module is connected.
● Offset
Stapler Fold
tray ● Fold type
○ Multi half fold
○ Multi tri-fold-in
Center staples—Staples the center of the booklet (Multi half fold
only)
Finishing tab in the job parameters window 193