Konica Minolta bizhub PRESS C1100 - Manual (Page 192)

Parameter Option Description
Spine
Note: This option is available only when the imposition method is
set to Perfect Bound.
Determines where the signatures are joined at the center fold and
then stitched or bound.
The value that you enter depends on the paper size that you
choose.
Bleed ● Extends part or all of the printed image beyond the trimming
boundary.
● Ensures that an inaccurate cutting will not leave undesired white
space at the edge of the page.
● Produces sharp page boundaries with color that extends all the
way to the edge of the page.
The value that you enter depends on the paper size and imposition
method that you choose. You can select Maximum bleed or enter a
Custom bleed size.
Notes:
● You cannot extend the bleed beyond the sheet fold lines. Bleed
does not affect the position of a crop.
● Bleed must be defined in your DTP application in order for the
IC-312 print controller to be able to apply bleed options.
? Enables you to view help on spacing and marks.
Preview Enables you to view your imposition layout and settings. You can
open the Preview window at any time and keep it open to check
your imposition settings as you select them. The Preview window
dynamically reflects any changes that you make.
Creep Creep
Note: Creep is only available when imposition is set to Saddle
stitch, or when the Nested Saddle option is selected for the Perfect
Bound imposition method.
Creep is used to compensate for the physical shift of the inner
sheets of a saddle stitch booklet. Set the size of the page shift from
or towards the spine.
Provides the following options:
● Creep in
○ Auto—Automatically sets a value based on the paper's
weight.
○ Custom—Enables you to set a custom creep in value.
● Creep out—Enables you to set a creep out value (negative or
positive value).
182 Chapter 11—Job parameters