Konica Minolta bizhub PRESS C1100 - Manual (Page 88)

1. Position the measurement device at the start of the white box in
the strip.
2. Scan from the left white box across to the right white box.
A green check mark is displayed when the measurement is
successful. A red x mark is displayed if the measurement
fails.
c. Continue to scan the remaining strips on the color chart
pages.
8. (Optional) To save the measurement file and load it at a later
time, locate a folder and in the Save in box, type a name for
the measurement file.
9. (Optional) Click Save.
10. Click Next.
11. Click Create Profile.
This process might take a few minutes
12. In the Profile Name box, type a new name for the profile, or
leave the name that the Profiling Tool automatically created
based on the screening method.
13. To define the location for saving the destination profile, select
one of the following options:
○ Profile Manager—The profile automatically appears in the
Profile Manager area and in the job parameters window.
○ Other—The profile is saved in a specified location, and you
can later import the profile to the Profile Manager area.
14. Click Save to save the profile.
15. In the message that appears, click OK.
16. Click Finish to close the Profiling Tool.
Using the iSis automated chart reader to measure a
color chart and create a profile
Requirements: The press must already be calibrated.
78 Chapter 7—Managing color