HID FARGO HDP5000 User Guide - Manual (Page 77)

July 2013 Page 77 of 100
© 2012, 2013 HID Global Corporation. All rights reserved.
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
Printer Error
Message
Cause Solution
No Smart Card Encoder No Smart Card Encoder is
installed in the printer. To cancel, click
Cancel Print.
No Prox Card Encoder No Proximity Card Encoder is
installed in the printer. To cancel, click
Cancel Print.
Headlift Error The Headlift Sensor is not
detecting movement from the
Headlift Cam. Reboot the Printer by cycling power.
To cancel, press the
Cancel Print button.
Invalid Password The Password entered is not a
valid password. Press
OK to enter another password.
To cancel, press the
Cancel Print button.
Laminator (General
Error) The Laminator has reported a
general fault. Press the
Resume button located on the Printer to
continue.
To cancel, press the
Cancel Print button or the
Cancel button located on the Printer.
Laminator (Check
Power) The Laminator's power is OFF. Ensure that the laminator's power cord is properly
connected, cycle power and press the
Resume
button to continue.
To cancel, press the
Cancel Print button or the
Cancel button located on the Printer.
Laminator (Heater Off) The Laminator's Heater is OFF. Press the
Resume button to continue.
To cancel, press the
Cancel Print button or the
Cancel button located on the Printer.
Laminator (Heater Timed
Out) The Laminator cannot reach the
desired operating temperature. Reboot the Printer by cycling power. Check the
Laminator settings in the Printer Driver.
Click
Default located on the Lamination tab of the
driver to set the Laminator settings to the factory
default.
Resend the print job.
To cancel, press the
Cancel Print button or the
Cancel button located on the Printer.
No Laminator Film
Installed No laminator Film is installed in
the laminator unit. Ensure that the appropriate Laminator Film is
installed.
To cancel the print, press the
Cancel Print button
or the
Cancel button located on the Printer.
Wrong Laminator Film
Installed An incorrect laminator film has
been installed, or a driver
setting is incorrect. Ensure that the appropriate Laminator Film is
installed and press the
Resume button located on
the Printer to continue printing.
To cancel, press the
Cancel Print button or the
Cancel button located on the Printer.
Laminator Film Out The Film installed in the
laminator is empty. Install the Film and press
Resume.