HID FARGO HDP5000 User Guide - Manual (Page 5)

July 2013 Page 5 of 100
© 2012, 2013 HID Global Corporation. All rights reserved.
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
2.2 Safety Messages
2.2.1 United States (review carefully)
Symbol Critical Instructions for Safety purposes
Danger:
Failure to follow these installation guidelines can result in death or serious
injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the left).
To prevent personal injury, refer to the following safety messages before
performing an operation preceded by this symbol.
To prevent personal injury, always remove the power cord prior to performing
repair procedures, unless otherwise specified.
To prevent personal injury, make sure only authorized service personnel
perform these procedures.
ESD: This device is electrostatically sensitive. It can be damaged if exposed to
static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by a
warning symbol (as shown to the left).
To prevent equipment or media damage, refer to the following safety
messages before performing an operation preceded by this symbol.
To prevent equipment or media damage, observe all established Electrostatic
Discharge (ESD) procedures while handling cables in or near the Circuit
Board and Printhead Assemblies.
To prevent equipment or media damage, always wear an appropriate personal
grounding device (e.g., a high quality wrist strap grounded to avoid potential
damage).
To prevent equipment or media damage, always remove the Ribbon and
Cards from the Printer before making any repairs, unless otherwise specified.
To prevent equipment or media damage, take jewelry off of fingers and hands,
as well as thoroughly clean hands to remove oil and debris before working on
the Printer.
Caution: This symbol signifies electrical danger which may cause injury or death.