8 transfer temp offset, 9 print flip angle, 10 encoder flip angle – HID FARGO HDP5000 User Guide User Manual

Page 28: 11 print flip level, 12 ribbon print takeup tension, 13 using the ribbon print supply tension setting

HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0

Page 28 of 100

July 2013

4.7.8 Transfer Temp Offset

This option adds an offset to the printer temperature of the transfer roller.
Note: Use this setting only for making the temperature of the transfer roller and the LCD goal
match.

• Use the

Image Transfer tab slider to make adjustments for card stock.

• A negative (-) adjustment increases the actual roller temperature.

4.7.9 Print Flip Angle

Use the

Print Flip Angle option to set the position of the flipper so it is level with the card path

after a flip operation.

4.7.10 Encoder Flip Angle

Use the

Encoder Flip Angle option to fine-tune the position of the flipper.

Note: This setting is in relation to the printer's built-in encoder if your printer is equipped with
this option.

4.7.11 Print Flip Level

Use the

Print Flip Level option to set the position of the flipper so it is level with the card path.

4.7.12 Ribbon Print Takeup Tension

Use the

Ribbon Print Takeup Tension to set the tension of the color Ribbon during printing.

Adjust the Ribbon tension

if the Ribbon wrinkle is appearing on the card.

Note: Adjustments moderately change the image length.

4.7.13 Using the Ribbon Print Supply Tension Setting

This procedure controls the tension of the color Ribbon during printing. Adjust the Ribbon
tension

if the Ribbon wrinkle is appearing on the card.

Note: Adjustments moderately change the image length. “+” Adjustments can eliminate some
cases of wrinkle

Figure 9 - Ribbon Print Supply Tension