HID FARGO HDP5000 User Guide - Manual (Page 70)

HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
Page 70 of 100 July 2013
© 2012, 2013 HID Global Corporation. All rights reserved
LCD Error Message Cause Solution
Mag Verify Error
(PC Error Message No.
30)
Print could not verify MAG write.
OR
The magnetic stripe was not
encoded properly. Check the Cards and click
Cancel Print.
Multiple Feed
(PC Error Message No.
70)
Multiple cards were fed into the
Printer. Remove all cards and try again.
No E-card Encoder
(PC Error Message No.
202)
You are trying to send encoding
data, but the Printer is not
configured with this Encoder type. To cancel, click
Cancel Print.
No Film
(PC Error Message No.
28)
Film is not installed in the Printer.
OR
Film RFID tag is bad. Install the Film and press
Resume.
To cancel the print, press the
Cancel Print
button or the
Cancel button located on the
Printer.
No Flip Module
(PC Error Message No.
201)
Two-sided job sent to a one-sided
Printer. Verify the Printer has flipper capabilities
through the LCD Menu.
If Flipper capabilities are present, ensure that
the
Print Both Sides option in the Driver is
set correctly.
Press
Resume on the Printer’s Front Cover to
continue printing.
To cancel the print, press
Cancel Print from
the
Driver’s display dialog.
No Flip Module
(PC Error Message No. 45
and 201)
The desired lamination requires a
Flipper Module. Change the Cartridge location of the
Lamination material (if it is dual sided), or buy
a Flipper Module.
No iCLASS Encoder
(PC Error Message No.
177)
You are trying to send encoding
data, but the Printer is not
configured with this Encoder type. To cancel, click
Cancel Print.
No Mag Module
(PC Error Message No.
31)
MAG encoding job sent to Printer
without a MAG Encoder.
You are trying to send encoding
data, but the Printer is not
configured with this Encoder type. To cancel, click
Cancel Print.
No MIFARE Encoder
(PC Error Message No.
203)
You are trying to send encoding
data, but the Printer is not
configured with this Encoder type. To cancel, click
Cancel Print.
No Prox Encoder
(PC Error Message No.
32)
You are trying to send encoding
data, but the Printer is not
configured with this Encoder type. To cancel, click
Cancel Print.
No Ribbon
(PC Error Message No.
25)
No Ribbon is installed in the Printer.
OR
The Ribbon RFID tag is bad. Install the correct Ribbon and press
Resume
located o the Printer’s LCD display.
To cancel the print, press the
Cancel Print
button from the
Driver's display dialog and
the
Cancel button located on the Printer's
LCD display.