HID FARGO HDP5000 User Guide - Manual (Page 41)

July 2013 Page 41 of 100
© 2012, 2013 HID Global Corporation. All rights reserved.
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
4.9.8 Using the Use Substitute Panel Data
Only ribbons with the
F or I panel have this option available in the driver.
When selecting
Split Mode in the driver and the Flipper Module is present, the first page of
the document is printed to the front of the card with the YMC ribbon panel. Following, the
second page is printed on the front of the card with the F ribbon panel. Lastly, the third page is
printed on the back with the K ribbon panel.
When
Split Mode is not selected and the Flipper Module is present, the first page of the
document is printed to the front of the card with the YMC ribbon panel. Following, the second
page is printed on the front of the card with the Fluorescent ribbon panel. The third page is
printed on the back of the card with the YMC ribbon panel. Lastly, the fourth page is printed on
the back of the card with the F ribbon panel.
When enabling Use Substitute Panel Data - displayed is the following details.
4.9.8.1 YMCFK Ribbon
Split Ribbon ON (Duplex)
Page 1 is YMC on the front, Page 2 is F on the front, Page 3 is K on the back. WB entry and
“~” commands ignored.
Split Ribbon OFF (Duplex)
Page 1 is YMC on the front, Page 2 is F on the front, Page 3 is YMC on the back, Page 4 is F
on the back. WB entry and “~” commands ignored.
Split Ribbon OFF (Simplex)
Page 1 is YMCK on the front, Page 2 is F on the front. WB entry and “~” commands ignored.