HID FARGO HDP5000 User Guide - Manual (Page 58)

HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
Page 58 of 100 July 2013
© 2012, 2013 HID Global Corporation. All rights reserved
4.13.6 Selecting the Auto Detect Laminate button
Step Procedure
1 Check
Auto Detection for allowing the printer driver to correct the lamination values.
2 If
Auto Detection is unchecked and the lamination values do not match, the LCD displays a Wrong
Laminate error.
4.14 Using the K Panel Resin tab
Use this tab to adjust the
Print All Black with K Panel (options) and the Defined Areas. Use
this tab to control where the resin black (K) Panel of a full-color Ribbon is printed. (
Note:
When Disable Printing under the Device Options tab is selected, this tab will be active while all
functions will be grayed out.)
• If printing with a Ribbon type that does not have a K Panel, such as the YMC Ribbon
type, all K Panel Resin options will be grayed out. Resin black text is desirable due to its
sharp, saturated color and resin black barcodes are required to ensure readability when
scanned by an infrared barcode reader. (
Note: The Printer Driver will automatically
print all TrueType black text and TrueType barcodes only with the resin black (K) Panel
of the Print Ribbon by default.)
• If printing black text or barcodes that are not TrueType fonts or black graphics, select
one of the three options listed under
Print All Black with K Panel. (Note: The Printer
Driver will print areas of the image where it finds black coloring with the Print Ribbon's
resin black (K) Panel as specified by each of the following options.)
Figure 21 - K Panel Resin