HID FARGO HDP5000 User Guide - Manual (Page 69)

July 2013 Page 69 of 100
© 2012, 2013 HID Global Corporation. All rights reserved.
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
LCD Error Message Cause Solution
Lam1 Wrong Film
(PC Error Message No.
233)
Material in Cartridge 1 of the
Laminator does not match the
material type specified by the job. Make sure Driver material matches what is
actually in the Laminator.
Lam2 Wrong Film
(PC Error Message No.
234)
Material in Cartridge 2 of the
Laminator does not match the
material type specified by the job. Make sure Driver material matches what is
actually in the Laminator.
Laminate 1 Bad
(PC Error Message No.
259 and 261)
The Lamination material in
Cartridge 1 is not valid for this
Laminator. Install valid material.
Laminate 1 Jam
(PC Error Message No.
229)
A Jam occurred with the Laminator
material in Cartridge 1. Open Lam cover and clear the obstruction
Laminate 1 Low
(PC Error Message Nos.
239)
The material is getting low in
Lamination Cartridge 1. Make sure more is on hand for when it runs
out.
Laminate 1 Out
(PC Error Message No.
208)
The Laminate in Cartridge 1 has
run out. Replace it with a new roll of material.
Laminate 2 Bad
(PC Error Message No.
260 and 262)
The Lamination material in
Cartridge 2 is not valid for this
Laminator. Install valid material.
Laminate 2 Jam
(PC Error Message No.
230)
A Jam occurred with the Laminator
material in Cartridge 2. Open Lam cover and clear the obstruction.
Laminate 2 Low
(PC Error Message No.
240)
The material is getting low in
Lamination Cartridge 2. Make sure more is on hand for when it runs
out.
Laminate 2 Out
(PC Error Message No.
209)
The Laminate in Cartridge 2 has
run out. Replace it with a new roll of material.
Lm1 Headlift Err
(PC Error Message No.
217)
The Laminator failed to move or
sense the lower (Lam module 1)
head. Check head connections and call for
service/repair.
Lm2 Headlift Err
(PC Error Message No.
218)
The Laminator failed to move or
sense the upper (Lam Module 2)
head. Check head connections, call for
service/repair.
Mag Encoder Paused
(PC Error Message No.
143)
The Magnetic Encoder is in a pause
state. Reset the Printer and try again.
If this problem persists, call for technical
assistance.
Mag Encoder Startup
Error
(PC Error Message No. 63
and 141)
A problem was detected during
Printer start-up. Reset the Printer and try again.
If this problem persists, call for technical
assistance.