1 using the click and drag capability, 2 selecting “inches or mm” radio button, 3 using the add and delete buttons – HID FARGO HDP5000 User Guide User Manual

Page 59: 4 selecting the full card, 5 selecting the defined area(s), 6 selecting the undefined area(s)

July 2013

Page 59 of 100

HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0

4.14.1 Using the Click and Drag capability

Click and drag the corners and the sides of an area to change size and location of area.

• The Horizontal, Vertical size and X, Y coordinates update accordingly.

Click and drag the area to change the location.

• The X, Y coordinates update accordingly.

4.14.2 Selecting “inches or mm” radio button

Select from the

inches or mm radio button to change the measurement type. (Note: This is

similar to the choice on the Card tab.)

• The

inches radio button displays the area size and the location in inches.

• The

mm radio button displays the area size and the location in mm.

4.14.3 Using the Add and Delete buttons

Step

Procedure

Use the

Add button for these capabilities:

• Add an area default sized to .2 (.2 at location “0” with focus on the added area).
• Add multiple areas in the same location with the same affect (as if there were only one area).

(

Note: Intersecting/overlapping areas do not cancel each other out; instead, they act as one

area.)

Using the Delete button to delete the area with focus from the graphic.

4.14.4 Selecting the Full Card

Step

Procedure

Select the Full Card option to print the resin black (K) Panel for all black found within all areas of the
image, as shown below.

• The Card image becomes fully black.
• The resin prints anywhere for black.
• The Add and Delete buttons become inactive and are grayed out.
• The Defined Area object size and location scroll controls become inactive and are grayed out.
• The inches and mm dials become inactive and are grayed out.

4.14.5 Selecting the Defined Area(s)

Step

Procedure

Select the

Defined Area(s) option to print the resin black (K) Panel for all black found only in an area or

areas defined, as shown below.

• The card image becomes white with the grid and one area (available for the User to start with).
• The defined areas print black with resin.

4.14.6 Selecting the Undefined Area(s)

Step

Procedure

Select the

Undefined Area(s) option to print the resin black (K) Panel for all black found only in the

space outside the areas defined, as shown below.

• The card image becomes black with the grid and one area (available for the User to start with).
• The defined area does not print black with resin.