HID FARGO HDP5000 User Guide - Manual (Page 48)

HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
Page 48 of 100 July 2013
© 2012, 2013 HID Global Corporation. All rights reserved
4.11.2 Adjusting the Transfer Dwell Time and Temperature
Use
Image Transfer to control of the Transfer Dwell Time and Temperature.
• These settings control the speed and temperature at which printed images are
transferred from the InTM Film to the card. These settings may vary depending on the
card type.
• The Printer Driver automatically optimizes these settings according to the selection
made in the
Card Type option.
• Changes made to the Dwell Time and Temperature settings are saved for the selected
Card Type option (upon exiting the Printer Driver setup, from the Printer’s Control
Panel).
Step Procedure
1 Transfer Dwell Time Sets dwell time for InTM Film transfer in seconds per inch Lower limit = 1.0
seconds per inch, Upper limit = 3.0 seconds per inch
• UltraCard III - Composite: Default = 2.0 seconds per inch
• UltraCard - PVC: Default = 2.0 seconds per inch
• Custom: Default = 2.0 seconds per inch
2 Transfer Temperature Sets temperature for InTM Film transfer in Celsius Lower limit = 150.0 Celsius,
Upper limit = 210.0 Celsius
• UltraCard III - Composite: Default = 175 Celsius
• UltraCard- PVC: Default = 175.0 Celsius
• Custom: Default = 175.0 Celsius
3 Return to the factory default settings for the selected
Card Type by clicking on the Default button.
If using cards (that differ from the
Card Type Glossy-PVC or Matte-PVC options), select one of the
Card Type Custom options.
4 Adjust the dwell time and temperature settings to ensure proper image transfer. Determine the
appropriate settings for the card stock by setting the
Transfer Dwell Time and Transfer Temperature
to the default settings. Print a card.
a. If the InTM Film is not transferring properly, adjust these settings accordingly.
OR
b. If the InTM Film is transferring properly, perform a final durability test called the
Tape Test.
For instructions on how to do a tape test, see Conducting the Tape adhesion Test procedure.
5 Use the Default button to reset the
Transfer Dwell Time and Transfer Temperature to defaults for
current Card Type choice.