Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 96)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Bridge Media Status
Diplays the types of MAC frames that can be sent or received across each of the system's
interfaces.
Bridge Media Configuration
Displays configuration information used to negotiate the MAC types to be sent or
received.
Note - The current firmware version does not allow the Local Status parameter to be
configured. Attempting to configure this parameter will not result in an error but the new
value will not be applied.
IP over PPP
IP Info
Displays IP compression protocol status information for a particular PPP link.
IP Configuration Info
Displays IP compression protocol configuration information for a particular PPP link.
Note - The current firmware version does not allow the Compression parameter to be
configured. Attempting to configure this parameter will result in the error message: "The
error occurred with 'Set' operation. Error: noSuchName."
Note - The current firmware version does not allow the Administration Status parameter
to be configured. Attempting to configure this parameter will not result in an error but the
new value will not be applied.
PPP Security
Security Configuration Info
Displays the security configuration information for a particular PPP link.
Note - The current firmware version does not allow the Protocol parameter to be
configured. Attempting to configure this parameter will not result in an error but the new
value will not be applied.
Note - The current firmware version does not allow the Status parameter to be configured.
Attempting to configure this parameter will result in the error message: "The error
occurred with 'Set' operation. Error: noSuchName."
Security Secrets
Displays information on the identities and secrets used by the PPP authentication
protocols.
Note -The current firmware version does not allow the Protocol parameter to be
configured. Attempting to configure this parameter will not result in an error but the new
value will not be applied.
Note - Setting the Status parameter to 'invalid' clears the corresponding values of the
Identity and Secret parameters.
PN 613-50665-00 Rev C Page 96 of 294