Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 152)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - Please refer to Uplink Modules for the operations and behavior of the uplink modules
installed on these devices.
Note - To turn RPS monitoring on or off on the switch, from the switch command line interface
enter the command SET SYSTEM RPSMONITOR={ON|OFF}. To see whether RPS monitoring
is on, use the command SHOW SYSTEM. To turn on RPS monitoring using SNMP, set the
fanAndPsRpsMonitoringStatus variable to on.
Note - The current firmware version does not allow AT-View Plus Device Manager to support
the Reset button.
Note - The current firmware version does not allow AT-View Plus Device Manager to support
the RPS LED on the DC models.
Agent Menu
From the Agent menu, you can view and edit the system information for the switch, or log into
the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Power Supply Info
Displays information about the power supply, redundant power supply and power supply
monitoring. (AC models only)
File List
Displays a list of the files in the switch's flash file system.
Config File Name
Displays the file name of the start-up configuration file.
Telnet
Starts a Telnet connection to the switch.
WEB browser
Opens your web browser and connects to the switch's HTTP server.
Note - The web browser can only contact the device if the device has a valid resource file
loaded and set, and the HTTP server and GUI on the device are enabled.
Routing Menu
From the Routing menu, you can view and edit information about the switch's IP routing
functions.
PN 613-50665-00 Rev C Page 152 of 294