Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 145)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
Note - The MIB (atiStackSwitch.mib v2.10) supported by the current firmware version
defines the Module ID and Port ID parameters as "read-write". As a result, AT-View Plus
Device Manager displays these parameters as configurable objects. However, attempting
to configure these parameters will show that the firmware does not accept any value.
Note - The only valid MIB Set value for the Status parameter is 'destroy'. Attempting to
set this parameter to any other value may result in the value being ignored or the error
message: "The error occurred with 'Set' operation. Error: bad value."
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding
database and the spanning tree status.
Forwarding Database
Displays the Forwarding Database table.
Discard/Aging Time Info
Displays information about the number of address entries that were learned but discarded
because either there was a lack of memory or the entry's aging timer expired.
Spanning Tree Info
Displays spanning tree parameters such as priority and cost.
Statistics
Displays statistics about frames received/transmitted on the switch port.
RMON Menu
From the RMON menu you can view and edit the RMON MIB.
Statistics
Displays traffic statistics in the network segment attached to each port.
History Control Table
Displays the RMON History table.
PN 613-50665-00 Rev C Page 145 of 294