Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 85)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Status
Displays whether the port is enabled or disabled, whether it is partitioned and other status
information.
Detail Status
Displays information such as port name, LED status and polarity.
Note - A link between a port on the hub and a port on another device can only be
established if the port on the other device is configured to auto-negotiate.
Security Info
Displays source MAC addresses of frames received on the port.
Note - Valid MIB Set values for the Learn Action parameter are 'inactive' and 'active'.
Attempting to set this parameter to any other value will result in the error message "The
error occurred with 'Set' operation. Error: bad value.".
Note - The current firmware version does not allow the user to configure the MAC
Address parameter. Attempting to configure it will result in the error message "The error
occurred with 'Set' operation. Error: bad value.".
Enable
Enables the port.
Disable
Disables the port.
AT-FH800u
PN 613-50665-00 Rev C Page 85 of 294