Stacking menu, Expansion module notes, Stacking menu expansion module notes – Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT User Manual
Page 148

Allied Telesyn
AT-VIEW PLUS
DEVICE MANAGEMENT
Note
- The Mirroring Source Module, Mirroring Source Port and Mirroring Destination
Module parameters are not applicable to the AT-8500 series and should be ignored.
MAC Address Security
Displays MAC Address Security parameters and allows you to set the security level for
dynamic and static MAC addresses learned and assigned to a port.
Note
- The current firmware version allows the Security Threshold parameter to be set to
a value in the range [1-255] inclusive.
DoS Defense
Displays DoS Defense parameters and allows you to enable/disable a defense mechanism
on a port.
Note
- The Module ID and Port Number parameters under each Attack Type option do
not return valid values. They return "noSuchName.", "No such instance" or NULL.
Stacking Menu
From the Stacking menu, you can access slave switches and other Master switches in the
enhanced stack.
Stacking Info
Displays Enhanced Stacking parameters, allows you to set the switch's enhanced stacking
status and select a switch to manage in the enhanced stack.
Expansion Module Notes
Note
- When adding/removing/changing an expansion module, AT-View Plus Device
Manager does not automatically refresh the device image in the main window to reflect
the addition/removal/change. To view the updated device image, click on the Refresh
option under the Agent menu.
Note
- Configurable parameters under the Detail Info option cannot be modified for the
AT-A45 expansion modules. Attempting to do so will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error."
Note
- The AT-A45 expansion module ports cannot be enabled/disabled. Attempting to
do so will result in the error message: "The error occurred with 'Set' operation. Error: gen
Error."
Note
- The AT-A46 expansion module port cannot be manually set to 1000Mbps.
However, the current firmware version allows the Port Speed and Mode parameter for
this port to be set to '1Gbps full-duplex' or '1Gbps half-duplex'
PN 613-50665-00 Rev C
Page 148 of 294