Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 229)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Packet Content Rule
Displays ACL rule of user-defined information.
Note - The current firmware version does not allow the following parameters to be
configured:
o
Offset 0 to 15
o
Offset 16 to 31
o
Offset 32 to 47
o
Offset 48 to 63
o
Offset 64 to 79
RMON Menu
From the RMON menu you can view and edit the RMON MIB.
Statistics
Displays traffic statistics in the network segment attached to each port.
History Control Table
Displays the RMON History table.
Alarm Table
Displays the RMON Alarm table.
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Probe
Probe Config
Displays RMON probe information.
Note - The current firmware version returns 'noSuchName' for the Date and Time
parameter.
Network Interface Config
Displays configuration parameters for a particular network interface on this device.
Note - Valid MIB Set values for the Row Status parameter are 'active' and 'not in service'.
Attempting to set this parameter to any other value will result in error message: "The
error occurred with 'Set' operation. Error: bad value".
PN 613-50665-00 Rev C Page 229 of 294