Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 25)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Alarm Table
Displays the RMON Alarm table.
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on the port,
bytes received and transmitted on the port, and port status.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and 'down'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - Valid MIB Set values for the Port Flow Control parameter are 'disable', 'transmit-
only', 'receive-only', and 'transmit-and-receive'. However, the current firmware version
does not allow this parameter to be set to 'transmit-only' and 'receive-only' for the
following ports:
• Expansion module ports
• GBIC ports on the AT-8024GB
• Fiber optic ports on the AT-8026FC
• 10/100/1000Base-T ports on the AT-8026T
Note - Valid MIB Set values for the Port State parameter are 'enabled' and 'disabled'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."
Note - The current firmware version accepts up to 20 characters for the Port Name
parameter. Attempting to enter more than 20 characters will result in an error message
and may append additional characters to the input value.
PN 613-50665-00 Rev C Page 25 of 294