Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 157)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
System Info
Displays basic system information, including system name, location, contact and
description.
Note - Configuring the System Contact, System Name and System Location parameters
may sometimes result in the error message: "The error occurred with 'Set' operation.
Error: gen Error." However, the values are still set successfully.
Note - The current firmware version allows the user to enter up to 39 characters for the
System Contact and System Location parameters.
Firmware Info
Displays firmware version.
Network Info
Displays network-related information such as the addresses of the default gateway and the
agents.
Device Info
Displays general information about the switch.
Note - The current firmware version returns '???(0)' for the Uplink A Port Type and
Uplink B Port Type parameters.
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
ib v2.10) supported by the current firmware version
defines the Module ID and Port ID parameters as "read-write". As a result, AT-View Plus
Device Manager displays these parameters as configurable objects. However, attempting
to configure these parameters will show that the firmware does not accept any value.
Note - The MIB (atiStackSwitch.m
Note - The only valid MIB Set value for the Status parameter is 'destroy'. Attempting to
set this parameter to any other value may result in the value being ignored or the error
message: "The error occurred with 'Set' operation. Error: bad value."
Reset
Resets the switch.
Note - The current firmware version does not allow the Reset option to restart the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
PN 613-50665-00 Rev C Page 157 of 294