Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 48)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Expansion Module Notes
• Expansion module ports cannot be enabled/disabled. Attempting to do so will result in the
error message: "The error occurred with 'Set' operation. Error: gen Error".
• The Port Speed and Mode parameter of the 100/1000Base-T port on the AT-A14
expansion module can only be set to 'auto'. Attempting to set this to any other value will
result in the error message: "The error occurred with 'Set' operation. Error: gen Error".
• A GBIC image is always visible on the GBIC slot of the AT-A15 expansion module even
if there is no GBIC physically inserted.
• The Port Speed and Mode parameter of the 1000Base-X port on the AT-A15 expansion
module can only be set to '1Gbps full-duplex'. Attempting to set this to any other value
will result in the error message: "The error occurred with 'Set' operation. Error: gen
Error".
• The Port Speed and Mode parameter of the 100Base-FX port on the AT-A16, AT-A17,
and AT-A19 expansion modules can only be set to '100Mbps full-duplex'. Attempting to
set this to any other value will result in the error message: "The error occurred with 'Set'
operation. Error: gen Error".
AT-8324
PN 613-50665-00 Rev C Page 48 of 294