Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 95)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - The LQR Info sub-menu option does not display the correct parameters. Instead, it
displays the sub-menu option name as a parameter with a value of 'noSuchName'.
LQR Configuration
Displays Link Quality Report configuration information for a particular PPP link.
Note - The LQR Configuration sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
LQR Extensions
Displays information on the most recently received Link Quality Report packet for a
particular PPP link.
Note - The LQR Extensions sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
PPP Tests
Performs a PPP echo test or PPP discard test.
Note - The PPP Tests sub-menu option does not display the correct parameters. Instead, it
displays the sub-menu option name as a parameter with a value of 'noSuchName'.
MAC Bridging over PPP
Bridging Info
Displays information indicating whether the Bridge Network Control Protocol has
reached an opened state, the type of compression used, and use of LAN identification
field in packets.
Bridging Configuration Info
Displays bridging configuration information for a particular PPP link.
Note - The current firmware version does not allow the Administration Status parameter
to be configured. Attempting to configure this parameter will not result in an error but the
new value will not be applied.
Note - The current firmware version does not allow the following parameters to be
configured:
o
Tinygram
o
Ring ID
o
Line ID
o
LAN ID
Attempting to configure these parameters will result in the error message: "The error
occurred with 'Set' operation. Error: bad value."
PN 613-50665-00 Rev C Page 95 of 294