Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 216)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - Valid MIB Set values for the Row Status parameter are 'active' and 'not in service'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value".
Active Peer Info
Displays information about active peer relationships.
Note - The Active Peer Info sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
OSPF
Basic Info
Displays basic information about Open Shortest Path First routing protocol.
Note - The current firmware version does not allow the following parameters to be
configured:
o
AS Border Router Status
o
Type of Service Support Status
o
Ext Link State DB Limit
o Demand Extensions
Area Info
Displays the configured parameters and cumulative statistics of the device's attached
areas.
Note - The current firmware version does not allow the Authentication Type parameter to
be configured.
Stub Area Config
Displays the set of metrics that will be advertised by a default Area Border Router into a
stub area.
Note - The current firmware version does not allow the Row Status and Metric Type
parameters to be configured.
Link State Ads
Displays the OSPF Process's Link State Database.
Note - The Link State Ads sub-menu option does not display the correct parameters.
Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
Address Range Info
Displays the range of IP addresses specified by an IP address/IP network mask pair.
PN 613-50665-00 Rev C Page 216 of 294